Forum

Subiect: Amortizor Dt Swiss M210

#7801

Alin Busta
Postat de Alin Busta
Subiect deschis de la 23 septembrie 2016 la 12:03
Raporteaza
Buna ziua,ma poate ajuta cineva?Am si eu o intrebare ce presiune trebuie sa bag in shock DT SWISS M210 190X50mm,eu am 77 kg ca sa fie ok,adica nici prea mare nici prea mica,am cautat pe net un tabel ceva de genul dar nu am gasit nimic.
Va multumesc
Postat de Alin Busta la 23 septembrie 2016 la 12:03
0
0
NU-ti trebuie tabel. Reglezi presiunea dupa SAG.
https://www.youtube.com/watch?v=GhTZtLJ79J0
Postat de Dan Oltean la 23 septembrie 2016 la 12:51
0
0
https://www.dtswiss.com/Resources/Support/SHOCKS/DT-Swiss-Shocks-M210-User-Manual-en

Vezi capitolul 2A:
2.3
Step 1: Pump, until the correct sag is attained.
Inflate approx. 0,5 bar / 7 psi more, as some air may
escape when removing the pump.
CAUTION! Maximum pressure 18 bar / 255 psi!
CAUTION! Wear eye protection while releasing air!
Step 2: Push o-ring until it touches the rear shockhousing
(Fig. 1).
Step 3: Sit carefully on the bicycle seat (Fig. 2).
Step 4: Get off the bicycle and measure the
distance of the sag A (Fig. 3):
Built-in-length 152mm/6”➜A = 6-11mm/0.24-0.43”
Built-in-length 165mm/6.5”➜A = 8-13mm/0.31-0.51”
Built-in-length 190mm/7.5”➜A = 10-18mm/0.39-0.71”
Built-in-length 200 mm/7.87”➜A = 11-20mm/0.43-0.79”
Built-in-length 320mm/12.60”➜A = 13-22mm / 0.51-0.87”
Step 5: ➜ If distance A is larger than mentioned in
step 4: Inflate a little more air!
➜ If distance A is smaller than mentioned in step 4:
Release a little air (follow user’s manual of pump
manufacturer)!
Repeat step
Postat de Cristi Trifan editat la 23 septembrie 2016 la 15:02
0
0